Início
Ferramentas
Atualização de firmware- Destaques
Atualização de firmwarev1.2
Upload de registro de voov1.1
Portal USB Onlinev1.0
Configurador WiFi USB Onlinev1.1- Todas as ferramentas
3D parts toolv1.0
Calculadora de furo de arv1.0
API Altimeter Cloudv1.0
Preditor de altitudev1.0
Calculadora de resistência do tubov1.0
Calculadora de descidav1.0
Calculadora de carga de ejeçãov1.0
Programador web ESPv1.0
Calculadora de vibração de aletasv1.0- Atualização de firmwarev1.2
- Upload de registro de voov1.1
Verificação do registro de voov1.1
Designer de pecas laserv1.0- Portal USB Onlinev1.0
- Configurador WiFi USB Onlinev1.1
Calculadora de velocidade de trilhov1.0
Calculadora de derivav1.0
Calculadora de visibilidadev1.0
Update your Mercury V1
Make sure your device is connected and in boot mode, then click Connect.
Connecting to your device...
Wrong device connected
A full install erases the whole device, including saved settings, WiFi credentials, and any flight data still on the device. Choose Update unless you need a clean reset.
Installing...
⚠ Do not unplug the device or close this tab while installing.
All done!
Your device has been updated and is restarting.
Something went wrong
🔧 Troubleshooting
My device is not detected when I click Connect
Three things to check, in order:
- Cable. Many USB cables, especially short ones bundled with phone chargers, carry power only and have no data lines. Try a different cable, ideally one you know works for data transfer.
- USB port. Some USB hubs are unreliable. Plug directly into the computer if you can.
- Other software. If the Arduino IDE, PlatformIO, PuTTY, screen, or any serial monitor is currently open, close it. Only one program can hold the serial port at a time.
The browser does not show the Connect button
Web Serial is required and is supported only in desktop Chromium-based browsers — Chrome, Edge, Opera, Brave, and Vivaldi all work. Firefox and Safari do not. Mobile browsers do not either; you must be on a PC or laptop.
If you are on a supported browser and still do not see the Connect button, your browser may be out of date — update it and try again.
The flash starts but fails partway through
This is almost always cable movement. Even small bumps to a USB cable can interrupt the connection mid-write. Make sure the cable is firmly seated at both ends and avoid touching either the cable or the device while the progress bar is running.
If it keeps failing, try a different cable or a different USB port before assuming the device is at fault.
My computer went to sleep during the flash
Some computers cut power to USB ports when the screen sleeps, which interrupts the flash. If this happens, just put the device back into boot mode and run the update again — partial writes are recoverable.
For long updates it can help to temporarily disable sleep in your OS power settings.
I installed the wrong firmware — is my device broken?
No. Installing the wrong firmware will not damage your device. Put it back into boot mode and use the Full Install option to start fresh with the correct firmware.